In order to protect the cooler from breaking, the explosion-proof valve or bypass unloading circuit must be installed when the cooler is installed in the oil return circuit. The best way to use: using another small auxiliary to extract the oil tank inside the mature oil supply cooler, so as to become an independent loop.
In order to ensure that the cooler does not break, when the cooler is installed in the oil return circuit, it is necessary to install an explosion-proof valve or bypass unloading circuit. Recommend the best way to use: use another small pump, extract the oil tank internal heat supply cooler, so as to become an independent loop.
These pumps are high pressure and high performance, which have been developed especially for low noise operation.
To comply with a variety of applications including injection moulding machines, PV2R series single pumps provide the output flow of such a wide range as from 5.8 to 237 cm3/rev (.354 to 14.46 cu.in./rev).
The intergral driving parts of the pumps are combined into a kit form and available for supply as a cartridge kit. Therefore, the replacement of the driving parts can be done easily.
Product introduction:
1. Installed in the pump oil suction side, prevent pumping oil into the dirt, protection system.
2. Prolong pump and system service life, reduce work continuously generated when the fault.
3. Specification complete, the flow range 40 l/min~800 l/min, filtration precision 100(standard products) can provide higher filtration precision.
These double pumps consist of two PV2R seires single pumps combined in tandem within a single housing and driven by a common shaft. A Single suction port and two discharge ports are provided so that the output flow can be supplied to separate circuits.
These pumps are high pressure and high performance, which have been developed especially for low noise operation.
To comply with a variety of applications including injection moulding machines, PV2R series single pumps provide the output flow of such a wide range as from 5.8 to 237 cm3/rev (.354 to 14.46 cu.in./rev).
The intergral driving parts of the pumps are combined into a kit form and available for supply as a cartridge kit. Therefore, the replacement of the driving parts can be done easily.
These pumps are high pressure and high performance, which have been developed especially for low noise operation.
To comply with a variety of applications including injection moulding machines, PV2R series single pumps provide the output flow of such a wide range as from 5.8 to 237 cm3/rev (.354 to 14.46 cu.in./rev).
The intergral driving parts of the pumps are combined into a kit form and available for supply as a cartridge kit. Therefore, the replacement of the driving parts can be done easily.